how to install a washing machine drain

181 Metal strapping is easy to install for hanging pipes but one should use J hooks or other support that will stop uplift of pipes. Connect a standpipe to the drainpipe using a P-trap.

Washing Machine Not Draining 5 Causes And Fixes

Steps to install a washing machine drain pan.

. Clean the cut section of. These should easily unscrew and allow you to pop the hose off the mountings. Measure the size of the Y-fitting.

You may need pliers or a wrench to disconnect stuck on hoses. Use the pliers to hold. Various building codes require the uplift.

Place a bucket underneath this area and have a. Drain the hose to keep your floor surface dry and safe during installation. Turn off the supplies The first thing that you should do is to turn off the water supply and unplug the machine.

Set the pipe two inches from the adjacent wall and about 36 inches from the ground. Make sure you turn off both the hot and cold water that leads to the old machine before disconnecting it. Place the bent end of the drain hose into the drain pipe if its close to a wall.

Httpsamznto3NIFJuOMilwaukee M12 2 PVC Shear. Fortunately the next stage is a piece of cake. Afterwards glue another 10.

Within five-feet of the washer install a 2-inch tee fitting into the drainpipe for the vent pipe. Stick another ABS trap to the connection using the plastic pipe cement. First turn off the water supply hoses at the wall unplug the machine and disconnect the supply hoses and drain hose.

Proper installation method and location of drain hose. After that secure the drain hose with a hose clamp about 15 cm or 6 inches down into the drain. Next tilt the washer back so you can access the bottom front panel and you may need.

After installing the washer supply hoses move the washer into the required space. Fasten the transit bolts if you. Start by locating the clamps that hold the hose to the back of the machine.

Tape the loose cords to the back of the washing machine to keep them out of the way. Steps To Install A Washing Machine Drain Pipe. Unplug the washer then use an adjustable wrench to unscrew the existing water supply hoses placing the ends into a bucket to drain any water remaining in the lines.

The drain hose now pushes onto a spigot which in turn screws onto the u-bend. Plumbing into the u-bend is considerably easier and cheaper. Gather safety equipment and tools.

The spigot is usually tapered. Extend a vent pipe from the tee fitting into. Add a new drain hose to the system Its time to replace your old drain hose once youve removed it.

Httpamznto2kZThGY1 12 Union Trap. My Favorite Tool. Slide the hose onto the connection.

How To Connect A Laundry Sink And Washing Machine To The Same Drain